The 7.5″x 3.5″x 3.5″ (approx.) Dry Box is big enough for your wallet, cell phone, camera, cigars, etc. It seals tight to keep water out, and it holds firmly to your dash or other horizontal surface with our powerful 4.5″ SeaSucker. Two clips snap tight to keep the lid closed.
Scroll down to see a video of the Dry Box in action!
The Raymarine Ready transducer mounts are designed to fit in the existing Lowrance Ready location on the base of Hobie® Kayaks. These clamp the Dragonfly transducer onto the mounting plate giving it no chance of falling sideways.
This fits the Raymarine CPT-DVS Transducer
This is made from sturdy ABS plastic and comes with stainless steel fasteners required.
The Side bro is designed to hold you pliers, scissors, fish grips, small red Plano box and much more. This is a direct replacement for the Hobie® side pockets or any flat surface.
LH and RH in the Side Bros is available.
Product dimensions: 295mm Long x 105mm High x 50mm Deep
Plano box information – Plano Waterproof Stowaway 344
Fitting Rod holders and other accessories to RIB’s & Inflatable boats just got easier.
Now you can fit accessories like rod holders, bait boards, fish finders and more to RIB or Inflatable boats, SUPs and kayaks without hassle or messy glues. The new 3M VHB pad allows you to peel and stick the RIBPort mount, then fit any of your favorite RAILBLAZA accessories. The 3M VHB is now supplied with every RIBPort pack.
You no longer need a specialised outfitter, or to work with messy glues to install accessories to your RIB or Inflatable, with the RIBPort VHB pad you can install in the comfort of your own garage following the below instructions. Our team have run extensive trials on Hypalon, PVC & polyethylene inflatable craft and also recommend the VHB pad for use on epoxy SUP’s or surfboards.
The RIBPort can also be attached using the same glues as used to attach handles etc to RIB’s and inflatables.
The RAILBLAZA Visibility Kit II is a must-have safety item in the kit of any kayak angler, or recreational paddler. In one convenient, value-for-money pack you get everything you need for your kayak or canoe to be seen on the water day and night.
Simply mount the StarPort HD with the supplied fastenings, lock in the 1 metre (3’) Extenda Pole 1000, clip on the orange flouro flag for daytime visibility, and lock the Illuminate i360 – All-round White Navigation Light into the port on top for safety and regulatory compliance at night.
Disassembly when you’re finished is quick and easy, and it will store just about anywhere.
The i360 light can also be fitted to other RAILBLAZA ports around the kayak, and the Extenda Pole 1000 can be used to display a dive or national flag, or combined with RAILBLAZA camera mounts as a camera pole.
Designed and made in New Zealand using high quality materials, and the latest LED technology
3 operation modes;
Full brightness navigation mode 2NM – up to 25hrs battery life
Low brightness work mode – up to 160 hrs battery life
Flashing emergency Mode – over 200hrs battery life
Waterproof to 1 metre
Floats with lens clear of water
Powered by 3 x AA batteries, not supplied
Meets USCG 2NM 33 CFR 183.810 & ABYC A-16
Independently tested by Imanna Labs Inc, Florida
Supplied with StarPort HD, but will fit any other RAILBLAZA mounting port, ordered separately.
Flouro safety flag dimensions – 450mm (18 inches) x 200mm (8 inches)
RAILBLAZA 3 piece Extenda Pole can be configured as;
1 section height 380mm (15”)
2 sections height 680mm (27”)
3 sections height 980mm (38.5”)
The BerleyPro Orb is a 12v, 3 piece collapsible light perfect for that boat or kayak. With IP68 LEDs orientated at 360 degrees and angled over head this can be used as either an anchor light or permanent running light on your kayak. Our specific selection of LEDs are bright enough to let you land that tricky fish at night or setup your gear. This light runs on 12v so no more forgetting to charge your battery or paying for expensive smaller batteries as this can be connected in parallel with your fish finder.
This light is easy to install with only 2 wires needing to be connected and it comes with everything you need.
This light includes:
Super bright and waterproof IP68 LEDs
Extremely low current draw at 310mA
Railblaza mounting E port
Stainless steel fasteners
Waterproof fuse holder
3m of twin core marine cable
3 Piece 1.1m tall collapsible light
Glue lined heat shrink for installation
The RAILBLAZA Camera Boom 600 R-Lock is the best GoPro mount for your kayak, canoe, bass boat, yacht and/or other marine vessel.
It’s not going to end well if you take a selfie stick out on the water, which is exactly why we decided to make the extremely versatile Camera Boom 600. The RAILBLAZA Camera Boom 600 R-Lock is the best GoPro mount for your kayak, canoe, bass boat, yacht and/or other marine vessel.
Quality New Zealand made from high quality, waterproof and UV proof materials
Easy single-handed adjustment using R-Lock friction joints
R-Lock swivel joints can be locked, adjustable knuckle joint
Unscrew GoPro mount to use ¼ 20” screw
Light-weight and rigid with 5 adjustment axes
Quick release with a flick of the StarPort lock
Boom breaks into three pieces, for different mount heights
This innovative GoPro mount will hold your camera and capture the action for you! It can be used on kayaks, bass boats, sailboats, inflatables, motorcycles and any other type of vehicle. Compatible with any RAILBLAZA mount, this is the most versatile camera mount on the market.
There’s a reason why this fully adjustable GoPro extension mount is so popular! Like all RAILBLAZA products, this mounting extension arm is super easy to install and is the ideal way to mount your GoPro Hero 4, GoPro Hero 5 and all other brands of action cams. It certainly makes capturing those niggly wide shots a breeze while you’re on the water. It is one of the most popular GoPro mounting accessories on the market – it’s just like having an extra long GoPro selfie stick on steroids, you can literally mount it anywhere.
It should be called a GoPro Hero Stick or a GoPro waterproof pole, but whatever you want to call it, the RAILBLAZA Camera Boom 600 Pro Series works just beautifully. The GoPro mount can also be unscrewed to reveal a ¼ 20 thread for other camera types.